Energy Tech Laboratories DHG240 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wärmepumpen Energy Tech Laboratories DHG240 herunter. Energy Tech Laboratories DHG240 User's Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
CONTENTS
GENERAL.................................3
SAFETYCONSIDERATIONS..................3
AGENCYAPPROVALS ......................4
INSPECTION...............................4
INSTALLATION ............................4
OPERATION ..............................19
MAINTENANCE ...........................25
COMPLETE TABLE OF CONTENTS ON FOLLOWING PAGE
INSTALLATION
INSTRUCTION
SAVE THIS MANUAL
SUNLINE GAS/ELECTRIC
SINGLE PACKAGE
AIR CONDITIONERS
035-17233-000-C-0702
MODELS: DHG180 (15 TON, 10.0 EER)
DHG240 (20 TON, 9.7 EER)
208/230/575 VOLT
MODELS ONLY
208/230/460 VOLT
MODELS ONLY
Seitenansicht 0
1 2 3 4 5 6 ... 27 28

Inhaltsverzeichnis

Seite 1 - INSTRUCTION

CONTENTSGENERAL...3SAFETYCONSIDERATIONS...3AGENCYAPPROVALS ...4INSPECTION...

Seite 2 - TABLE OF CONTENTS

035-17233-000-C-070210 Unitary ProductsL.P. UNITS, TANKS AND PIPINGAll gas heat units are shipped from the factory equipped fornatural gas use only. T

Seite 3 - SAFETY CONSIDERATIONS

035-17233-000-C-0702Unitary Products 11Check all connections for leaks when piping is completed,using a soap solution. NEVER USE A FLAME.VENT AND COMB

Seite 4 - INSPECTION

035-17233-000-C-070212 Unitary ProductsFIGURE 9 : ENTHALPY SETPOINT ADJUSTMENT

Seite 5 - FIGURE 2 : CENTER OF GRAVITY

035-17233-000-C-0702Unitary Products 13TABLE 6: PHYSICAL DATAMODELSDHG180 240EVAPORATORBLOWERCentrifugal Blower (Dia. x Wd. in.)15 x 15 18 x 15Fan Mot

Seite 6 - DUCTWORK

035-17233-000-C-070214 Unitary ProductsFIGURE 10 : UNIT DIMENSIONS DHG180 & 240 (FRONT VIEW)RETURN AIRSUPPLYAIRBOTTOM SUPPLYAND RETURNAIR OPENINGS

Seite 7

035-17233-000-C-0702Unitary Products 15NOTE: A 1” clearance must be provided between any com-bustible material and the supply air ductwork for a dista

Seite 8 - TABLE 3: CONTROL WIRE SIZES

035-17233-000-C-070216 Unitary ProductsTABLE 11: DHG 15 TON SUPPLY AIR BLOWER PERFORMANCEDHG180 - BOTTOM DUCT CONNECTIONS1, 2BLOWERSPEED,(RPM)MOTORPUL

Seite 9 - P O W E R W I R I N G

035-17233-000-C-0702Unitary Products 17TABLE 12: DHG 20 TON SUPPLY AIR BLOWER PERFORMANCEDHG240 - BOTTOM DUCT CONNECTIONS1, 2BLOWERSPEED,(RPM)MOTORPUL

Seite 10

035-17233-000-C-070218 Unitary ProductsTABLE 13: STATIC RESISTANCES1DESCRIPTIONRESISTANCE, IWGCFM15 TON 20 TON4500 5765 7200 6000 7000 9400WET COIL0.1

Seite 11

035-17233-000-C-0702Unitary Products 19OPERATIONCOOLING SYSTEMThe cooling section is a complete factory package utilizing anair-cooled condenser. The

Seite 12 - 12 Unitary Products

035-17233-000-C-07022 Unitary ProductsTABLE OF CONTENTSGENERAL ...3SAFETYCONSIDERATIONS ...3REF

Seite 13 - TABLE 9: DHG ELECTRICAL DATA

035-17233-000-C-070220 Unitary Products3. A Low Pressure Switch/Loss Of Charge to protectagainst loss of refrigerant charge. (Opens at 7 psig + 3andre

Seite 14 - 14 Unitary Products

035-17233-000-C-0702Unitary Products 213. Redundant Gas Valve - There are two separate gasvalves in the furnace. Each valve contains a main and aredun

Seite 15 - TABLE 10: UTILITIES ENTRY

035-17233-000-C-070222 Unitary Products5. Set room thermostat to desired temperature.(If thermo-stat set temperature is above room temperature, pilotb

Seite 16

035-17233-000-C-0702Unitary Products 23Reverse the above procedure to replace the assemblies.Make sure that burners are level and seat at the rear of

Seite 17

035-17233-000-C-070224 Unitary ProductsADJUSTMENT OF TEMPERATURE RISEThe temperature rise (or temperature difference between thereturn air and the hea

Seite 18 - TABLE 13: STATIC RESISTANCES

035-17233-000-C-0702Unitary Products 25MAINTENANCENORMAL MAINTENANCEPeriodic maintenance normally consists of changing or clean-ing filters and (under

Seite 19 - OPERATION

035-17233-000-C-070226 Unitary Products1. Remove the burner assembly as outlined in BURNERINSTRUCTIONS.2. Remove the roof over the gas heat section.3.

Seite 20 - FIGURE 14 : GAS VALVE PIPING

035-17233-000-C-0702Unitary Products 271. The indoor blower motor is a non-inherently protectedthree-phase motor. Protection is provided by an overloa

Seite 21 - START UP

Subject to change without notice. Printed in U.S.A.Copyright © by Unitary Products 2002. All rights reserved. Supersedes: 035-17233-000 Rev B (0500) 0

Seite 22 - C A R R Y - O V E R T U B E

035-17233-000-C-0702Unitary Products 3D 1 HG 180 E 180 25 ECGENERALYORK Model DHG units are single package high efficiencygas-fired central heating fu

Seite 23 - FIGURE 19 : BELT ADJUSTMENT

035-17233-000-C-07024 Unitary ProductsREFERENCEAdditional information on the design, installation, operationand service of this equipment is available

Seite 24 - 1.08 °FbTempbRise×

035-17233-000-C-0702Unitary Products 5LOCATIONUse the following guidelines to select a suitable location forthese units.1. Unit is designed for outdoo

Seite 25 - MAINTENANCE

035-17233-000-C-07026 Unitary Productscombustion and ventilation air in accordance with Section5.3, Air for Combustion and Ventilation of the National

Seite 26 - TROUBLESHOOTING

035-17233-000-C-0702Unitary Products 7CONDENSATE DRAINPlumbing must conform to local codes. Use a sealing com-pound on male pipe threads. Install a co

Seite 27

035-17233-000-C-07028 Unitary ProductsCOMBUSTION DISCHARGEThe products of combustion are discharged horizontallythrough two screened (hooded) openings

Seite 28

035-17233-000-C-0702Unitary Products 9FIGURE 5 : TYPICAL FIELD WIRINGTABLE 4: GAS HEAT APPLICATION DATA1Input Capacity (Mbh) Output Capacity (Mbh)Avai

Kommentare zu diesen Handbüchern

Keine Kommentare